Enviro DV36 User Manual

Page of 40
10
Maintenance And Service
C
LEANING
 D
ECORATIVE
 S
URFACES
:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been 
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the 
finish,  including  cleaners,  polish  and  finger  prints.  It  is  important  to  note  that  fingerprints  and  other 
marks can leave a permanent stain on plated finishes. To avoid this, give the face a quick wipe with 
denatured alcohol on a soft cloth BEFORE lighting the fireplace.  Never clean the face when it is 
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into 
the surface.
If  your  fingers  come  into  contact  with  the  antique  copper  finish,  the  oils  left  as  fingerprints  on  the 
copper can cause discoloration, which will eventually turn green in that area. You can clean the patina 
or  discoloured  areas  of  the  antique  copper  finish  with  “OO”  3M  green  sanding  pads.  These  can  be 
purchased from most hardware stores. On the areas with discoloration, use the sanding pads to sand 
in the same direction as the brushed finish, then blend the finish by feathering in the surrounding area. 
This refinishing procedure has been approved by the manufacturer and will not harm the finish. Please 
note: ANTIQUE COPPER IS THE ONLY FINISH THAT CAN BE SANDED, DO NOT SAND PEWTER, GOLD 
OR NICKEL FINISHES.
G
LASS
 D
OOR
 R
EMOVAL
:
In order to install the log set, and 
for regular cleaning, the glass door 
must  be  removed.  There  are  two 
(2)  door  latch  mechanisms  under 
the  glass  door  shown  in  Figure 
7.  Each  latch  has  two  (2)  finger 
grooves,  use  these  to  pull  the 
mechanisms  straight  out.  When 
the  bottom  latches  are  unhooked, 
lift  the  door  straight  up  over  the 
placement  pins  at  the  top  of  the 
door, shown in Figure 8. 
To  replace  the  glass  door,  simply 
reverse the above procedure.
Warning: Do not touch or attempt 
to remove the glass if the fireplace 
is not completely cold.
WARNING:  Never  operate 
the  fireplace  with  the  glass 
removed.
Door latch
mechanism
Door latch
mechanism
Finger grooves
Finger
grooves
Figure 7. Bottom latches for glass.
���� ��������� ����
Figure 8. Top pins for glass door.