Enviro ENVIRO User Manual

8

Operating Instructions

A)  Make sure the pilot is lit.

B)  Turn  gas  control  knob  COUNTER 

CLOCKWISE to ON.

C)  Flip the burner switch to ON.

D) Turn  HI/LO  knob  to  the  desired  flame 

height.

E)  Turn on all electrical power to the unit.

NOTE: Check that all burner holes are lit.

TO TURN GAS FIREPLACE OFF:
Flip switch to OFF to turn off burners only.
If the fireplace is to be turned off for the season, or for servicing, turn the gas shut off valve to OFF.  DO 

NOT FORCE IT. If the unit is going to be serviced, turn off the electrical power to the unit as well.
NOTE: When the unit is turned on for the first time, it should be turned onto high, with the fan OFF, 

for the first two to four hours. This will cure the paint, logs, gasket material, and other products used 

in the manufacturing process. It is advised that a door or window be opened as the unit will start to 

smoke, which can irritate some people. After the unit has gone through the first burn, turn the unit OFF, 

including the pilot, and let the unit get completely cold. Then remove the glass and clean it with a good 

gas fireplace glass cleaner, available at your local Enviro dealer. See “M

AINTENANCE

 A

ND

 S

ERVICE

; G

LASS

 

D

OOR

 R

EMOVAL

” and “M

AINTENANCE

 A

ND

 S

ERVICE

; C

LEANING

 T

HE

 G

LASS

.”

This fireplace can use an optional remote control or an optional cordless wall thermostat.  If either of 

these are to be used to control the fireplace for the majority of the time, leave the ON/OFF switch (on the 

control panel) in the remote/thermostat position.  Consult the instructions included with the remote/wall 

thermostat for operation guidelines.

Retreat & Fascia

Creaking when heating up or cooling down.

Burner

Light pop or poof when turned off; this is more common with LP units.

Temperature Sensor

Clinking when it senses to turn the blower on or off.

Pilot Flame

Quiet whisper while the pilot flame in on.

Blower / Fan

Air movement that increase and decreases with the speed of the blower. 

The blower is pushing the heat from the fireplace into the room.

Gas Control Valve

Dull click when turning on or off, this is the valve opening and closing.