Mitsubishi P336 User Manual

[ 

IV  Remote Controller ] 

- 71 -

HWE09120

GB

<Entry found>

<No entries found>

(C) To return to the normal display
When all the group settings and interlock settings are made, take the 
following step to go back to the normal display. 
       Press and hold buttons       [FILTER]  and       [LOUVER]   
       simultaneously for 2 seconds to go back to the 
       window as shown in step     .

(2) Address search
    To search for the address of indoor units that have been entered into
    the remote controller, follow steps     and     .

(A) To search group settings

 Unit 

type

(Indoor unit in this case)

- When only one unit address is registered, the same address
   will remain on the display regardless of how many times the
   button is pressed.
- When the address of multiple units are registered
   (i.e.  011,     012,     013  ), they will be displayed one at a time in 
   an ascending order with each pressing of button       [TIMER ] .

To delete an address, go to 
section (3)  Address Deletion.

To go back to the normal display, 
follow step

(Displayed alternately)

To delete an address, 
go to section (3)   Address Deletion .

Bring up the address of another registered unit on the 
display.
- After completing step     , a subsequent pressing of button
       [TIMER] will bring up the address of another registered 
  unit.
  (The display method is the same as the one in step     .)

Address of an interlocked 
LOSSNAY unit

Address of another 
interlocked unit

Bring up on the display the address of the LOSSNAY unit 
that was interlocked with the indoor unit in step     . 
- With each pressing of button      [TIMER], the address of the  
  LOSSNAY and indoor unit that is interlocked with it will be 
  displayed alternately.

LOSSNAY can be searched in the same manner by bringing up 
the LOSSNAY address in the Interlocked unit address display window.

(B) Interlock setting search

After performing step     , proceed as follows:

Bring up the address of the indoor unit to be searched on 
the display.
- Select the address of the indoor unit to be searched by pressing
   button     [TIMER SET (    ) or (    )] to advance or go back
   through the interlocked addresses.

To go back to the normal display, 
follow step

To search for an address, 
go to section (2)  Address Search.

(Displayed alternately)

Bring up the   Group Setting   window.
- Each pressing of button        [TIMER ] will bring up the address of a   
   registered indoor unit and its unit type on the display.

E

1

2

E

10

E

13

13

6

E

H

10

The addresses of the indoor units that have been entered into the remote controller can be deleted by deleting the group settings.
The interlock settings between units can be deleted by deleting the interlock settings.
Follow the steps in section (2)  Address Search  to find the address to be deleted and perform deletion with the address being displayed in the 
display window. To delete an address, the address must first be bought up on the display. 

     Delete the registered indoor unit address or the interlock setting between units.
    - Press button   ? [CLOCK    ON    OFF] twice while either the indoor unit address or the address of the interlocked unit is displayed on the
      display to delete the interlock setting.

F