Sanyo CH0951 User Manual

Set screw only for transportation

Rear panel

▲

 marks

Left 
tubing

Right tubing

Downward tubing

Right-rear 
tubing
(recommended)

Left-rear 
tubing

(1) Remove and discard the set screw on the rear panel. (Fig. 6)

(2) Press the 2 

▲

▲

marks on the frame cover and disengage the sta-

tionary tabs from the frame. (Fig. 7)

(3) Remove the rear panel.

Tubing can be extended in 5 directions (KHS0951, KHS1251 and

KHS1852) as shown in Fig. 8a or 8b. Select the direction you need

providing the shortest run to the outside unit.

(1) Place the rear panel from the indoor unit on the wall at the loca-

tion selected. Make sure the panel is horizontal, using a carpen-

ter’s level or tape measure to measure down from the ceiling.

Wait until after cutting the hole before attaching the rear panel to

the wall.

(2) Determine which side of the unit you should make the hole for

tubing and wiring. (Fig. 9) 

(3) Before making the hole, check carefully that no studs or pipes

are directly run behind the spot to be cut.

●

●

(a)

Locate the drain hose and the drain cap. (Fig. 8c)

(b)

Remove the drain hose on the right side by pushing and

turning the hose connector counter-clockwise to release it.

(Fig. 8c)

(c)

Apply moderate force to pull off the drain cap on the left

side. (If you cannot pull it off by hand, use a long-nose pli-

ers.)

(d)

Reattach the drain hose to the left side and the drain cap

to the right side. (Fig. 8c)

The above precautions are also applicable if tubing goes through the

wall in any other location.

Left
tubing

Right-rear
tubing
(recommended)

Right tubing

Downward tubing

60

°

Drain hose

Clamp

Drain cap

To slip on

To remove

01-385 AirCon  12/11/01 4:41 PM  Page 6