Manualsbrain.com
  1. Manuals
  2. Brands
  3. Sanyo
  4. XHX1252
  5. User Manual

Sanyo XHX1252 User Manual

Download
Page of 114
2-39
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Remote Control Functions
Selecting the DC fan motor tap (when setting from the PCB)
●
 
4-way Air Discharge Semi-Concealed type
<Procedure> Stop the system before performing these steps.
 Open the electrical component box cover, then check the indoor unit control PCB. 
 Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin 
on the indoor unit control PCB according to the setting number which was confirmed in Table 1 (Table of DC 
Fan Motor Tap Settings).
• If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit 
control PCB.
• If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit 
control PCB.
●
 
Suspended type
<Procedure> Stop the system before performing these steps.
 Open the electrical component box cover, then check the indoor unit control PCB. 
 Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin 
on the indoor unit control PCB according to the setting number which was confirmed in Table 2 (Table of DC 
Fan Motor Tap Settings).
• If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit 
control PCB.
• If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit 
control PCB.
●
 
1-way Air Discharge Semi-Concealed type
<Procedure> Stop the system before performing these steps.
 Open the electrical component box cover, then check the indoor unit control PCB.
 Connect the jumper connector (2P: yellow) which was supplied with the accessory to the correct connector pin 
on the indoor unit control PCB according to the setting number which was confirmed in Table 3 (Table of DC 
Fan Motor Tap Settings).
• If the setting No. is (1), then connect the jumper connector to the connector pin TP1 (2P: red) on the indoor unit 
control PCB.
• If the setting No. is (3), then connect the jumper connector to the connector pin TP3 (2P: yellow) on the indoor unit 
control PCB.
3. Timer Remote Controller (RCS-TM80BG)
TP6
White Yellow Red
TP3 TP1
SM830157_W-2WAY_ECO-i.indb   39
SM830157_W-2WAY_ECO-i.indb   39
2007/06/08   14:23:40
2007/06/08   14:23:40