GE ASQ28 User Manual

4

■ 

To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.

■ 

The remote control signal has a range of up 
to 21 feet.

■ 

Make sure nothing is between the air conditioner
and the remote control that could block 
the signal.

■ 

Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.

Features and appearance will vary.

Turns air conditioner on and off.

Displays the set temperature or time
remaining on timer.

Use to set the air conditioner to Cool or Fan
mode.

▲ 

▼

Use to set temperature when in Cool mode.

Use to set the fan speed at Low, Med or High.

Controls the fan.

On—The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off.

Off—The fan runs all the time, while 
the compressor cycles on and off.

This switch must be set at Off in order to use
the fan settings (on the mode control).

On—When the air conditioner is off, it can be
set to automatically turn on in 1 to 24 hours
at its previous setting. Each touch will set the
time in hours.

Off—When the air conditioner is on, it can 
be set to automatically turn off in 1 to 24
hours. Each touch will set the time in hours.

To cancel the timer, press the Timer pad 
until the display time disappears.

(on some models)

Press to set the air conditioner to run for 
8 hours before it automatically shuts off.

One hour after the sleep timer is set, the set
temperature will automatically increase 2°F.

To cancel the sleep mode, press the Sleep pad
a second time.

Note: The sleep timer will be cancelled if the
Timer, Energy Saver or Mode pad is pressed.

ENERGY 
SAVER On

TIMER On 

COOL On

FAN On

SLEEP On