Monessen Hearth DFX24C User Manual

Page of 36
33D4047
3
DFX & DBX Series Vent Free Fireplaces
IMPORTANT SAFETY INFORMATION
W
ARNING
  Any change to this heater or its controls can be dangerous.
  Improper installation or use of the heater can cause serious injury or 
death from fire, burns, explosion or carbon monoxide poisoning.
  Do not allow fans to blow directly into the fireplace. Avoid any drafts that 
alter burner flame patterns.
  Do not use a blower insert, heat exchanger insert or other accessory, 
not approved for use with this heater where applicable.
INSTALLER
Please leave these instructions with the appliance.
OWNER
Please retain these instructions for future reference.
1.  Due to high temperatures, the appliance should be 
located out of traffic and away from furniture and 
draperies.
.  Children and adults should be alerted to the hazard 
of high surface temperature and should stay away 
to avoid burns or clothing ignition.
3.  Young children should be carefully supervised when 
they are in the same room with the appliance. 
4.  Do not place clothing or other flammable material 
on or near the appliance. 
5.  Any safety screen or guard removed for servicing 
an appliance, must be replaced prior to operating 
the heater.
6.  Installation and repair should be done by a qualified 
service person.
7.   To prevent malfunction and/or sooting, an unvented 
gas heater should be cleaned before use and at 
least  annually  by  a  professional  service  person. 
More  frequent  cleaning  may  be  required  due  to 
excessive  lint  from  carpeting,  bedding  materials, 
etc.  It  is  imperative  that  control  compartments, 
burners and circulating air passageways be kept 
clean.
8.   CARBON  MONOXIDE  POISONING:  Early  signs  of 
carbon monoxide poisoning are similar to the flu with 
headaches, dizziness and/or nausea. If you have these 
signs, obtain fresh air immediately. Have the heater 
serviced as it may not be operating properly.
9.  The installation must conform with local codes or, in 
the  absence  of  local  codes,  with  the  National  Fuel 
Gas Code, ANSI Z223.l/NFPA54.
10.  Do not install the DFX model in a bathroom or bedroom. 
The DBX model may be installed in a bedroom, but 
not in a bathroom.
11.  Do not install the heaters in a bathroom or bedroom.
1.  Correct installation of the ceramic fiber logs, proper 
location of the heater, and annual cleaning are neces-
sary to avoid potential problems with sooting. Sooting, 
resulting from improper installation or operation, can 
settle on surfaces outside the fireplace. Refer to log 
placement instructions for proper installation.
13.  Avoid any drafts that alter burner flame patterns. Do not 
allow fans to blow directly into fireplace. Do not place 
a blower inside burn area of firebox. Ceiling fans may 
create drafts that alter burner flame patterns. Sooting 
and improper burning will occur.
14.  Caution:  Candles,  incense,  oil  lamps,  etc.  produce 
combustion byproducts including soot. Vent-free appli-
ances will not filter or clean soot produced by these 
types of products. In addition, the smoke and/or aro-
matics (scents) may be reburnt in the vent-free appli-
ance which can produce odors. It is recommended to 
minimize the use of candles, incense, etc. while the 
vent-free appliance is in operation. 
15.  This  is  an  unvented  gas-fired  heater.  It  uses  air 
(oxygen) from the room in which it is installed. Provi-
sions for adequate combustion and ventilation air must 
be provided. Refer to Page 8. 
16.  Keep  room  area  clear  and  free  from  combustible 
materials, gasoline and other flammable vapors and 
liquids.
17.  Unvented gas heaters are a supplemental zone heater. 
They are not intended to be the primary heating appli-
ance. 
18.  Unvented  gas  heaters  emit  moisture  into  the  living 
area.  In  most  homes  of  average  construction,  this 
does  not  pose  a  problem.  In  houses  of  extremely 
tight construction, additional mechanical ventilation is 
recommended. 
19.  During manufacturing, fabricating and shipping, various 
components of this appliance are treated with certain 
oils, films or bonding agents. These chemicals are not 
harmful but may produce annoying smoke and smells 
as they are burned off during the initial operation of the 
appliance; possibly causing headaches or eye or lung 
irritation. This is a normal and temporary occurrence.
 
The initial break-in operation should last two to three 
hours with the burner at the highest setting. Provide 
maximum ventilation by opening windows or doors to 
allow odors to dissipate. Any odors remaining after this 
initial break-in period will be slight and will disappear 
with continued use.