Dakota Digital LAT-NR101 User Manual
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the mounting plate from the bottom of the assembly; it is attached with two 3/8” 6-32
machine screws.
6. Pass the wires through the housing where the original bulb and socket where.
7. Feed the wires through the larger hole in the mounting plate and guide it to the bottom of the
housing. The flat side of the mounting plate should be on the outside of the housing and the
side with the slight raised center should go into the tail light housing. This will properly align the
mount in the original housing.
side with the slight raised center should go into the tail light housing. This will properly align the
mount in the original housing.
8. Now hold the LED assembly centered over the hole where the original bulb was and align the
mounting plate from the bottom with the slot in the housing. Position the LED assembly so the
screw holes line up.
screw holes line up.
MAN# 650195