Runco LS-10D User Manual

Installing the Anamorphic Lens Transport Assembly: After installing the Transport 
Assembly Attachment Plate and Ceiling Mount Plate, proceed as follows to install the 
Anamorphic Lens Transport Assembly. 

1.

Position the flat side of the motorized transport against the bottom side of the 
Attachment Plate so that the center “M” hole in the Attachment Plate is aligned with 
the front recessed transport hole.

2.

Insert the #10-32 pivot screw up through the transport and Attachment Plate and 
loosely complete the assembly with the corresponding washer, lock washer and nut.

3.

Loosely insert the four small 3/8” screws through the four remaining “M” slots through 
the top of the Attachment Plate and down into the transport.

4.

Separate the Anamorphic Lens and lens bracket. Locate the lens bracket mounting 
screws and use them to attach the bracket to the transport assembly. Observe the 
sticker on the plate showing the correct sequence for installing and tightening the 
screws. 

Screw, Phillips PH,
#6-32 x 3/8" (4)

Lock Washer, #10-32 (1)

Flat Washer, #10-32 (1)

Nut, #10-32 (1)

Pivot Screw, Phillips PH,

#10-32 x 5/8" (1)