Runco LS-100d User Manual
Lightstyle™ Series LS-100d Installation/Operation Manual
29
PRE
L
IMINAR
Y
Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-12. For more information about configuring and using this
connection, refer to Network on page 58.
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-12. For more information about configuring and using this
connection, refer to Network on page 58.
Figure 3-12. Ethernet Network Connection to DHD Controller
Connecting to AC Power
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the LS-100d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
receptacle on the rear of the LS-100d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
To Accessory Box
IR
Display Control
HDMI 3
HDMI 4
Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
To Accessory Box
IR
Display Control
HDMI 3
HDMI 4
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
1
8
to Ethernet
Hub, Router
or Gateway
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
2 Transmit Data -
3 Receive Data +
6 Receive Data -