Runco LS-100d User Manual

The LS-100d lens focus controls are located 
beneath a hinged door on the top of the 
projector. To access them, press down on the 
door edge closest to the mirror and open the 
door.

Use the Coarse Focus Adjust dial to adjust the 
focal length in large increments. Use the Fine 
Focus Adjust dial to adjust the focal length in 
small increments. 

By default, the LS-100d is configured for a “floor/front” installation, in which the projector 
is installed upright and in front of the screen. If it is mounted on a ceiling, you must change 
the picture orientation. To do this:

1.

On the DHD Controller remote control or front panel, press MENU.

2.

Select Service from the Main Menu and enter the Service Menu passcode. 

3.

Select Display Device from the Service Menu.

4.

Select Configure from the Display Device menu, then select Installation.

5.

Select Orientation, then choose Ceiling/Front, to match the installation method. Or, 
for front-projection installations, use the Auto setting to have the projector 
automatically determine the orientation (floor or ceiling) using an internal sensor.