Runco X-200i User Manual

1.

Ensure that the projector is powered on and displaying 3D content.

2.

Press and hold the Power Button for about two seconds, then release the button. The 
LED then blinks in a pattern that indicates the battery charge state. In general, the 
more slowly and less frequently the LED blinks, the more charged (and less in need of 
charge) the glasses are. Refer to Table 4-3. 

3.

The glasses will sync with the emitter and the 3D content will be visible through the 
glasses. 

4.

Repeat Step 2 for each pair of glasses you wish to sync to the emitter. 

If the glasses do not detect an emitter, the LED blinks on and off once per second for five 
minute. Then, to preserve battery life, the glasses automatically turn off. If the emitter is 
activated (the emitter is only active when the projector is in 3D mode) before the 
five-minute period ends, the glasses stop blinking and remain on. 

If the glasses automatically turn off, press the Power button to turn them back on. 

Three (3) blue blinks (one 
second on, one second off)

Battery is fully charged; 12 to 15 hours remaining. 

Six (6) blue blinks 

Battery is 50% charged; approximately 4 hours remaining. 

Nine (9) blue blinks 

Battery is 30% or more charged; approximately 2 hours remaining. 

Red blink

Battery charge is 10% or less; glasses must be charged before 
further use.