Runco X-200i User Manual

The lamp should be replaced when it reaches the end of its life (typically between 1,500 
and 3,000 hours), or sooner if a noticeable degradation in brightness occurs. Contact your 
Runco dealer to obtain a replacement lamp.

1.

Turn off the projector and unplug the power cord. Allow the projector to cool 
down for approximately 60 minutes prior to removing the lamp assembly for 
replacement. 

2.

Open the rear door of the projector 
by grasping the handle and pulling it 
downward. 

 

 

 

 

 

 

 

 

 

 

 

3.

Loosen the captive screw on the 
lamp cover and pull the lamp cover 
out.

 

 

 

 

 

 

 

 

 

 

4.

Loosen the two screws on the lamp 
module.

5.

Pull the lamp module handle firmly to 
remove the lamp module. 

6.

Perform Steps 5 through 2 (in reverse 
order) to install the new lamp 
module. 

7.

Turn on the power. The lamp timer 
will reset automatically.