Emerson Series 3000 MVD User Manual
Configuration and Use Manual
25
Installation
Using the
Dis
p
la
y
Di
gi
gi
tal
Comm
Comm
un
ic
ic
atio
ns
Se
tu
p
Se
tu
p
Be
fo
fo
re
Y
Y
o
u
Begin
Chapter 4
Using the Display and Menu System
4.1
About this chapter
This chapter explains how to use the Series 3000 display and menu system. Using the display, you can
move through the menus, configure the application, monitor and control the application, and perform
maintenance and diagnostic tasks.
move through the menus, configure the application, monitor and control the application, and perform
maintenance and diagnostic tasks.
4.2
Startup display
When the Series 3000 device is powered on, it automatically tests its display. During display testing,
the screen darkens for approximately five seconds. After the display test is completed:
the screen darkens for approximately five seconds. After the display test is completed:
1. The Micro Motion logo is displayed for two to three seconds.
2. An application list is displayed for two to three seconds.
3. The device enters operation mode:
•
If the discrete batch application is not installed, the process monitor screen is displayed, as
shown in Figure 4-1.
shown in Figure 4-1.
•
If the discrete batch application is installed, the batch process screen is displayed (see
Figure 18-1).
Figure 18-1).
Figure 4-1
Process Monitor screen
4. If there are any active alarms, the alarm category will be displayed in the alarm bar. To view,
acknowledge, or respond to the alarms, see Chapter 22.
5
←
DEVICE 1
→2
Mass Flow Rate
2.33
g/s
Mass Total
485.88
g
RESET
EXIT
Security
button
button
Alarm bar
VIEW or EXIT
button
button