Philips AZ5160 User Manual

21

AZ 5160/98  

page

21

CD/VCD OPERATION
"NO" is displayed

– Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens has 

cleared.

– Replace or clean the disc, see "Maintenance"
– Use a readable disc or correct recorded format 

MP3-CD.

No picture on TV screen

– Connect the cable between the system and TV.

No colour on TV

– Change the system to the respective PAL or 

NTSC setting.

RADIO RECEPTION
Radio reception is poor

– If the signal is too weak, adjust the antenna 

for better reception.

– Increase the distance between the Receiver 

and your TV or VCR.

TAPE OPERATION/RECORDING
Recording or playback cannot be made

– Clean deck parts, see "Maintenance".
– Use only NORMAL (IEC I) tape. 
– Apply a piece of adhesive tape over the missing 

tab space.

GENERAL
The system does not react when buttons

– Slide the source sector to TAPE/OFF. Remove and

pressed/set does not work/no display on

reconnect the AC power plug for 30 seconds and

LCD.

switch on the set again.

Sound cannot be heard or is of poor

– Adjust the volume.

quality

– Make sure the MP3-CD was recorded within 

32-320 kbps (128kbps preferably) with sampling
frequencies at 8 - 48 kHz (44.1kHz preferably).

The remote control does not function

– Reduce the distance between the remote control

properly

and the system.

– Insert the batteries with their polarities (+/- signs) 

aligned as indicated.

– Replace the batteries.
– Point the remote control in the direction of the 

system's IR sensor.

If a fault occurs, first check the points listed below before taking the set for repair. 
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.