Hearth & Home Technologies CB1200I-B User Manual
R
Septemer 1, 2008
7014-083E
Page 15
CB1200-I Pellet Insert
C. Full Reline With Outside Air
Figure 15.1
Outside Air
Termination
Termination
at
Chimney Top
Outside Air
through
Rear Wall
through
Rear Wall
Exit through the
Ash Clean-Out of
Masonry Chimney
12” (305mm)
min. below
min. below
12” (305mm)
min. above
min. above
NOTE; Use metal
plate around
exhaust vent pipe
and seal all edges
with non-flammable
insulation such as
fiberglass, mineral
wool or ceramic.
plate around
exhaust vent pipe
and seal all edges
with non-flammable
insulation such as
fiberglass, mineral
wool or ceramic.
Do not use high
temperature caulk-
ing materials to seal
any edge to prevent
future serviceability
temperature caulk-
ing materials to seal
any edge to prevent
future serviceability
NOTE: Check clearances carefully for this
type of installation to ensure adequate room
for outside air venting.
type of installation to ensure adequate room
for outside air venting.
Check building codes prior to installation.
• Installation MUST comply with local, regional,
• Installation MUST comply with local, regional,
state and national codes and regulations.
• Consult local building, fire officials or authorities
having jurisdiction about restrictions, installa-
tion inspection, and permits.
tion inspection, and permits.
CAUTION
NOTE: In Canada, only a full reline is
allowed per ULC S-628, ORD ULC C1482.
allowed per ULC S-628, ORD ULC C1482.