Hearth & Home Technologies SANTAFEI-B User Manual
R
September 1, 2008
7019-205C
Page 19
Santa Fe Pellet Insert
D. Door Handle Removal
E. Door Trim Installation
Figure 19.1
Tools Requied: 5/32 Allen wrench
NOTE: The door handle must be removed before the
trim ring can be installed.
trim ring can be installed.
1. Open the door. Using a 5/32 Allen wrench, loosen set
screw by a couple of turns, but do not remove.
Figure 19.1.
Figure 19.1.
2. Push the pin completely out and remove the handle.
3. Re-install in reverse order.
Tools Required: Phillips head screwdriver. (A stubby
screwdriver required if door is still installed on the
insert).
screwdriver required if door is still installed on the
insert).
1. Remove the door handle first by following the instructions
above. Using a Phillips head screwdriver, remove the 2
screws on the top and bottom of the face. Figure 19.1.
screws on the top and bottom of the face. Figure 19.1.
2. Pull the face away from the door by rotating the face
toward you from the hinge side first. Carefully push the
door handle through the opening on the face.
door handle through the opening on the face.
3. Lay the face (face up) on a protected surface to avoid
scratching the trim when installing it in step 5.
4. Line up the studs on the trim with the holes in the face and
push studs into the holes.
5. Turn the face and trim over. Secure with 6 nuts provided.
Do not overtighten.
6. Thread the door handle through the face opening and
insert the pin through the door handle and door latch.
Re-tighten the set screw.
7. Re-attach to the door using the same 4 screws previously
removed.
F. Door Removal
1. Remove the door handle and face. Follow instructions
from D and E above.
2. The door can now be lifted off the hinges.
3. Re-install in reverse order.