Bang & Olufsen 1 User Manual

The BeoSound 1 has a built-in 24 hour 
clock. You must set the clock yourself.

If you want to make use of the  
Wake-up Timer function described on 
the next page, you must first make sure 
that the built-in clock in the BeoSound 1 
has been set correctly. If BeoSound 1 
has been disconnected from the mains 
for approximately 30 minutes, the clock 
must be set again.

You must set the built-in clock manually while 
BeoSound 1 is in standby.

While BeoSound 1 is in standby, 
press   and   simultaneously 
and hold until the time is shown 
in the display. Both the digits 
and the dot are blinking

If no time is set, the display will 
show lines instead of digits

Press   or   to find the correct 
time. Holding down   or   
will accelerate the change in 
numbers

Press STORE to store the correct 
time. The time is briefly shown 
in the display

Set the right time

The stored time can be shown briefly in the 
display.

Press both   and   shorty. The 
time is shown briefly in the 
display, the dot is blinking

While BeoSound 1 is in standby, 
press the STANDBY button to 
see the time in the display

NOTE! Pressing the red button on the Beo4 remote 
control will show the time in the display

11

20.00

--,--

14.25

15.00

14.25

14.25