Philips 37PFL4606H User Manual

43

English

Cannot remove ‘e-sticker’ banner displayed on 

the TV.

 • To remove the logos and images, set the 

location of your TV to home.

1. Press  .

2. Select [Setup] > [TV settings] > 

[Preferences] > [Location].

3. Select [Home] and press OK. 

TV channel issues

Previously installed channels do not appear in 

the channel list:

 • Check that the correct channel list is 

selected.

No digital channels were found during the 

installation:

 • Check that the TV supports DVB-T, DVB-T 

Lite or DVB-C in your country. 

Some channels are not automatically installed 

on my TV:

 • During installation, make sure that you 

select the country where you are installing 

the TV.

Picture issues

The TV is on, but there is no picture:

 • Check that the antenna is properly 

connected to the TV.

 • Check that the correct device is selected 

as the TV source.

There is sound but no picture:

 • Check that the picture settings are 

correctly set.

There is poor TV reception from an antenna 

connection:

 • Check that the antenna is properly 

connected to the TV.

 • Loudspeakers, unearthed audio devices, 

neon lights, high buildings and other large 

objects can influence reception quality. 

If possible, try to improve the reception 

quality by changing the antenna direction 

or moving devices away from the TV.

9 Troubleshooting

This section describes commonly encountered 

issues and accompanying solutions.

General TV issues

The TV does not switch on:

 • Disconnect the power cable from the 

power outlet. Wait for one minute then 

reconnect it.

 • Check that the power cable is securely 

connected.

The remote control is not working properly:

 • Check that the remote control batteries 

are correctly inserted according to the 

+/- orientation.

 • Replace the remote control batteries if 

they are flat or weak.

 • Clean the remote control and TV sensor 

lens.

The standby light on the TV blinks red:

 • Disconnect the power cable from the 

power outlet. Wait until the TV cools down 

before reconnecting the power cable. If the 

blinking reoccurs, contact Philips Consumer 

Care. 

You forgot the code to unlock the TV lock 

feature

 • Enter ‘8888’.

The TV menu is in the wrong language.

 • Change the TV menu to your preferred 

language.

When turning the TV on/off/to standby, you 

hear a creaking sound from the TV chassis:

 • No action is required. The creaking sound 

is normal expansion and contraction of the 

TV as it cools down and warms up. This 

does not impact performance.

EN