Philips 37PFL4606H Manuel D’Utilisation

Page de 51
43
English
Cannot remove ‘e-sticker’ banner displayed on 
the TV.
 • To remove the logos and images, set the 
location of your TV to home.
1. Press  .
2. Select [Setup] > [TV settings] > 
[Preferences] > [Location].
3. Select [Home] and press OK. 
TV channel issues
Previously installed channels do not appear in 
the channel list:
 • Check that the correct channel list is 
selected.
No digital channels were found during the 
installation:
 • Check that the TV supports DVB-T, DVB-T 
Lite or DVB-C in your country. 
Some channels are not automatically installed 
on my TV:
 • During installation, make sure that you 
select the country where you are installing 
the TV.
Picture issues
The TV is on, but there is no picture:
 • Check that the antenna is properly 
connected to the TV.
 • Check that the correct device is selected 
as the TV source.
There is sound but no picture:
 • Check that the picture settings are 
correctly set.
There is poor TV reception from an antenna 
connection:
 • Check that the antenna is properly 
connected to the TV.
 • Loudspeakers, unearthed audio devices, 
neon lights, high buildings and other large 
objects can influence reception quality. 
If possible, try to improve the reception 
quality by changing the antenna direction 
or moving devices away from the TV.
9 Troubleshooting
This section describes commonly encountered 
issues and accompanying solutions.
General TV issues
The TV does not switch on:
 • Disconnect the power cable from the 
power outlet. Wait for one minute then 
reconnect it.
 • Check that the power cable is securely 
connected.
The remote control is not working properly:
 • Check that the remote control batteries 
are correctly inserted according to the 
+/- orientation.
 • Replace the remote control batteries if 
they are flat or weak.
 • Clean the remote control and TV sensor 
lens.
The standby light on the TV blinks red:
 • Disconnect the power cable from the 
power outlet. Wait until the TV cools down 
before reconnecting the power cable. If the 
blinking reoccurs, contact Philips Consumer 
Care. 
You forgot the code to unlock the TV lock 
feature
 • Enter ‘8888’.
The TV menu is in the wrong language.
 • Change the TV menu to your preferred 
language.
When turning the TV on/off/to standby, you 
hear a creaking sound from the TV chassis:
 • No action is required. The creaking sound 
is normal expansion and contraction of the 
TV as it cools down and warms up. This 
does not impact performance.
EN