Lucent Technologies 8.2 User Manual
DEFINITY ECS Release 8.2
Administrator’s Guide
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
1032
Trunk Group
17
Type
This field specifies the signaling type to be used with TN760B (or later release),
TN722 (with any suffix), TN767, TN2140 (when the Trunk Signaling Type field
is
TN722 (with any suffix), TN767, TN2140 (when the Trunk Signaling Type field
is
cont
), TN437, TN439, TN464 with any suffix, or TN458 circuit packs.
The Type column appears when the Trunk Signaling Type field is blank or cont.
The Type column does not display if the Trunk Signaling Type field is dis
The Type column does not display if the Trunk Signaling Type field is dis
!
CAUTION:
Customers should not attempt to administer this field. Please contact your
Lucent representative for assistance.
Lucent representative for assistance.
Ans Delay
!
CAUTION:
Customers should not attempt to administer this field. Please contact your
Lucent representative for assistance
Lucent representative for assistance
This delay serves two purposes:
■
It ensures that the answer supervision signal is valid and not a secondary
delay-dial or wink-start signal.
delay-dial or wink-start signal.
Valid entries
Usage
t1 stan
t1 comp
t5rev
The value of
t5 rev
is allowed only for the TN760D vintage 10
or later. When Type is
t5 rev
, Mode must be
e&m
.
type 5
Valid entries
Usage
20
to
5100
in
increments of
20
20
Specifies the length of time (in ms) your switch will wait
before it sends answer supervision for incoming calls on tie
trunks using the TN722A or later, TN760 (B, C, or D), TN767,
TN464 (any suffix), TN437, TN439, TN458, or TN2140 circuit
packs.
before it sends answer supervision for incoming calls on tie
trunks using the TN722A or later, TN760 (B, C, or D), TN767,
TN464 (any suffix), TN437, TN439, TN458, or TN2140 circuit
packs.
blank
Same as setting the field to zero.