Lucent Technologies 8.2 User Manual

Issue 1

April 2000

Features and technical reference 

1329

Extended User Administration of Redirected Calls 

To use Extended User Administration of Redirected Calls from off-site, you must 
first access the telecommuting-access extension. If you make the request via 
Direct Inward Dialing (DID), you must precede the extension with the correct 
public-network prefix. If you make the request via a trunk group dedicated to 
remote access of this feature, you must dial the public-network number for the 
trunk group.

The system provides dial tone after you access the telecommuting access 
extension. At that point you can enter only one of the four FACs associated with 
this feature. The 4 FACs associated with Extended User Administration of 
Redirected Calls are:

■

Extended Call Fwd All Activate

■

Extended Call Fwd Busy D/A Activate

■

Extended Call Fwd Deactivation

■

Change Coverage

When the system provides dial tone, you can proceed with the steps outlined for 
on-site use of the feature in 

‘‘Training users’’ on page 301

.

To interrupt the command sequence and begin again, you can enter an asterisk (*) 
at any point before the second pound sign. The system provides dial tone, and you 
can begin the command sequence at the point of entering your extension. (You 
should not enter the FAC again.) The interrupted command sequence is not 
recorded as an invalid attempt.

■

Bridged Appearance

When the pound key (#) is pressed from a bridged appearance immediately 
following any of this feature’s four FACs, the system assumes the currently 
active bridged extension will be administered. The station security code of 
the currently active bridged extension must be entered after the initial # to 
successfully complete the command sequence.

If the station has only bridged appearances, the station’s extension must be 
dialed after the FAC to successfully complete the command sequence, 
since the station’s extension is not associated with any appearances.