Lucent Technologies Release 7 User Manual
DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1432
SNI-BD (SNI Circuit Pack)
9
Replacing an SNI Circuit Pack
—
Simplex PNC
!
WARNING:
Do not power down a Switch Node carrier to replace a circuit pack.
!
WARNING:
Replacing a Switch Node Interface, Switch Node Clock, Expansion
Interface or DS1 Converter circuit pack on a simplex system disrupts
service. The service effect can range from outage of a single EPN to outage
of the entire system.
Interface or DS1 Converter circuit pack on a simplex system disrupts
service. The service effect can range from outage of a single EPN to outage
of the entire system.
1.
Enter busyout board UUCSS
UUCSS represents the cabinet-carrier-slot
address of the circuit pack to be replaced.
address of the circuit pack to be replaced.
2.
Replace the circuit pack
3.
Wait for the circuit pack to reset
Red and green LEDs will light and then go out.
4.
Enter release board UUCSS
!
CAUTION:
Do not busyout any Expansion Interface
circuit pack after this point.
circuit pack after this point.
5.
Enter test alarms long clear for
category exp-intf.
category exp-intf.
6.
Wait 5 minutes for SNI-BD, FIBER-LK
AND DS1C-BD alarms to clear, or
enter clear firmware counters a-pnc.
AND DS1C-BD alarms to clear, or
enter clear firmware counters a-pnc.