Lucent Technologies Release 7 User Manual

Issue 4

June 1999

Maintenance Commands 

8-162

monitor system 

If the system technician presses HELP after entering “monitor system”, the 
following object command word choices will be displayed:

conn         view1          view2

scr

If the system technician presses HELP after entering “monitor system conn” the 
following message will be displayed:

 Enter 3 port network numbers (xx-xx) [’pnn’ x x x]

If the pnn number entered is non numeric, not administered, or invalid in any 
other way, one of following messages will be displayed:

 Object command word omitted; please press HELP

“xx” is an invalid identifier; press RETURN to execute modified command

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

 Command resources busy; Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

This specifies a form that will include the attendant status, the 
maintenance status, the last hour’s measurement of trunk groups, hunt 
groups, and the attendant group, and finally, the time of day.

This specifies a form that will display a subset of the view1 form entries. 
This form will include all of the view1 form except the last hour’s hunt 
group measurements.

This option will bring up the connection monitor output for key 
information.

entering no 
options

Omitting the “pnn # # #” argument on the command line will cause the 
default configuration of Pnn’s 1, 2 and 3 to be displayed.

Entering “pnn # # #”, where “#” is replaced by a pnn number from 1 to 
3, will cause data for the specified pnns to be displayed.