American Dynamics RAS917 User Manual

 

SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY 

8200-0184-09, REV. A 

OPERATOR’S MANUAL SUPPLEMENT 

5 of 13

 

Refer to the SpeedDome Ultra VII Operator’s 
Manual for information about displaying menus and 
changing settings. 

1. Select 

Alarms/Areas/Home/Presets/PZ from 

the Dome Configuration Menu. 

2. Select 

Scan Limits. 

The Scan Limits screen appears: 

SCAN LIMITS

PAN to LEFT limit

ZOOM to mark BOUNDARY

Cancel RIGHT limit to Delete

CANCEL

 

 Press Focus during steps 3 or 4 to cancel 

scan limit programming. 

3.  Adjust the pan position of the dome to set the 

left scan limit. Press Zoom to select. 

4.  Pan the dome to the right to set the right scan 

limit. Press Zoom to select. 

5. When 

the 

Alarms/Areas/Home/Presets/PZ 

screen appears, select Exit to return to the 
Dome Configuration Menu. 

The AD Up-the-Coax (AD-UTC) protocol is a new 
protocol developed by American Dynamics. It 
provides video and two-way dome control signals 
on a single cable for compatible American 
Dynamics switchers and keyboards.  

 At the time of publication, the following 

American Dynamics keyboards are compatible with 
AD-UTC protocol: ADCC0200 and ADCC0300. 
The commands provided in this document assume 
that one of these keyboards is being used. Contact 
your Sales Representative for current information.  

Table 3 lists the commands to operate the 
configuration utility in AD-UTC environment. The 
keyboard must be in programming mode to 
perform these functions. 

 + 

 

(Function, and 
then Shift+Menu) 

Start the configuration utility. 

Joystick 

(Pan/Tilt) 

Move the highlight bar on the 
active menu. 

 (Focus Far) 

Or  

(Focus Near)

Select the highlighted item on 
the active menu. 

 (Zoom In) or 

Twist joystick 
clockwise 

Increase the value of the 
selected setting. 

Display the next choice for the 
setting.  

 

 (Zoom Out) 

or Twist joystick 
counterclockwise 

Decrease the value of the 
selected setting. 

Display the previous choice for 
the setting.  

 + 

 

(Function, and 
then Shift+Clear) 

Save changes and exit the 
utility from any screen. 

When setting names or entering password 
information, the screen displays the available 
characters in the selected language. Table 4 
provides the name programming and password 
entry commands: 

Joystick 
Left/Right 

Move the highlight left or right 
in the character field. 

Joystick Up/Down  Move the highlight up or down 

in the character field. 

 (Focus Far) 

Or  

(Focus Near)

Select the highlighted 
character in the character 
field.