Little Wonder LB901-00-01 User Manual

Refer to the engine manual for engine operation.

Little Wonder recommends using SAE 30 Oil.  

The use of multi-viscosity oil will result in high oil 

consumption and possible engine damage.

Leaves, thatch or other debris can be directed into 

windrows or piles, by simply maneuvering the unit 

and directing the flow of air accordingly.

Air flow can be directed to the side or front by the 

two-position deflector.  The front discharge position 

is used to remove debris from along walls, fences, 

etc. The side discharge position is used to form 

windrows or piles.  The horizontal deflector directs air 

downward to “chisel” under wet, heavy leaves and 

litter.  Air velocity is regulated by the throttle control.

Moving the deflector to the upper hole allows for a 

greater volume of air to be directed downward. 

Moving the deflector to the lower hole allows for 

a greater volume of air to be directed upward.  To 

reduce windrowing or to blow over an obstacle, point 

deflector upward.

Slight changes in deflector position will have a big 

effect on air flow.  Experiment until you find the best 

position for your needs.

For best performance, be sure engine recoil starter 

assembly, the blower intake and outlet areas are 

always kept clear and free of leaves or other debris.

Keep all nuts, bolts, and screws tight.

Never store the blower with fuel in its fuel tank inside 

a building or in a confined space where fumes may 

reach an open flame or sparks.

Always refer to the instruction manual for important 

details if the product is to be stored for an extended 

period.

Engine - 4 cycle. (Refer to engine manufacturer’s 

operating instructions for fuel recommendations and 

additional information.)

Tires - Tubeless. Inflate to air pressure of 30 P.S.I.

Labels should be inspected before each use. 

Replace damaged labels immediately.

Be sure correct oil level is maintained.  Check oil 

level after every 5 hours of operation, or daily, before 

starting engine.  Use SAE 30 oil.  Change oil after 

first 5 hours of operation.  Remove drain plug and 

drain oil while engine is warm.  Replace drain plug. 

Remove oil fill plug and refill with new oil.  Start and 

run engine at idle for 30 seconds.  Stop engine.  Wait 

30 seconds and re-check oil level.  If required, add oil 

to overflowing at oil fill plug.