Jacuzzi J-220 User Manual
page 4
3. Turn On Power
Turn on power to spa at the home’s circuit breaker. The heater and
filter/circulation pump will automatically activate. If the control panel
LCD flashes water temperature and “COL” or “ICE”, refer to page
29 for additional information.
filter/circulation pump will automatically activate. If the control panel
LCD flashes water temperature and “COL” or “ICE”, refer to page
29 for additional information.
4. Activate Jets Pump 1
Depress the JETS button on the control panel once to activate
jets pump #.
jets pump #.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 3.0 “Water Quality Maintenance”
(page 27) for general guidance.
Jacuzzi dealer. See section 3.0 “Water Quality Maintenance”
(page 27) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3 ppm and 5 ppm. To
ensure healthy water conditions, always maintain a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual. If sanitizer levels cannot be stabilized, perform the decon-
tamination procedure steps 9-5 on page 5-6. Note: the “decon-
tamination procedure” steps 9-15 should also be used after the spa
has been “Winterized” (section 12.7, page 26 ) or has been sitting
without power for an extended period.
ensure healthy water conditions, always maintain a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual. If sanitizer levels cannot be stabilized, perform the decon-
tamination procedure steps 9-5 on page 5-6. Note: the “decon-
tamination procedure” steps 9-15 should also be used after the spa
has been “Winterized” (section 12.7, page 26 ) or has been sitting
without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
steps:
•
The LCD display on the control panel displays the actual tempera-
ture of the spa water. Press either the COOLER (-) or WARMER
(+) button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER (-) or WARMER (+) within 5 seconds. The set tempera-
ture increases or decreases by one degree each time one of these
buttons is pressed.
ture of the spa water. Press either the COOLER (-) or WARMER
(+) button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER (-) or WARMER (+) within 5 seconds. The set tempera-
ture increases or decreases by one degree each time one of these
buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum water temperature setting for your spa is 04°F
• The maximum water temperature setting for your spa is 04°F
(40°C) and the minimum setting is 80°F (27°C).
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.