Jacuzzi J-220 User Manual
page 6
CAUTION: never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals!
while the cover is open and accessible to small children and
animals!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in section 12.2 “Draining And Refilling” (page 25).
12. Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. Do NoT oVERFILL.
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. or, you
may fill entirely with hard water if you use a special water addi-
tive available from your authorized Jacuzzi dealer.
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. or, you
may fill entirely with hard water if you use a special water addi-
tive available from your authorized Jacuzzi dealer.
13. Consult your authorized Jacuzzi dealer for chemical recommenda-
tions, then add chemicals to spa water to achieve a constant sani-
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual.
tizer reading within the levels recommended by the Association of
Pool And Spa Professionals/USA printed on the inside cover of this
manual.
14. Turn on all jet(s) pumps when adding chemicals to ensure proper
mixing and leave your spa cover open until the sanitizer level falls
below 5 ppm to protect pillows and plastic knobs from chemical
below 5 ppm to protect pillows and plastic knobs from chemical
attack.
CAUTION: Never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals.
while the cover is open and accessible to small children and
animals.
CAUTION: To prevent the unlikely possibility of contracting a
waterborne illness, maintain water chemistry within step 6 pa-
waterborne illness, maintain water chemistry within step 6 pa-
rameters. If you or other bathers experience such a condition,
discontinue use and seek medical attention.
discontinue use and seek medical attention.
15. Establish a sanitizer reading between 3 ppm and 5 ppm, then allow
the spa to set undisturbed for 8 hours. Retest water after 8 hours to
determine if sanitizer levels are stable. If sanitizer levels are stable,
your spa is ready for use. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on
the inside cover of this manual. If sanitizer levels are not stable at
this time, it will be necessary to repeat this procedure in its entirety
(steps -5) until stable sanitizer readings are achieved.
determine if sanitizer levels are stable. If sanitizer levels are stable,
your spa is ready for use. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on
the inside cover of this manual. If sanitizer levels are not stable at
this time, it will be necessary to repeat this procedure in its entirety
(steps -5) until stable sanitizer readings are achieved.