Agilent Technologies 24A User Manual
2- 12
Front-Panel Overview
To use analog channels to view a signal
To use analog channels to view a signal
• To configure the oscilloscope quickly, press the
Autoscale
key to display
the connect signal.
• To undo the effects of Autoscale, press the
Undo Autoscale
softkey before
pressing any other key.
This is useful if you have unintentionally pressed the
Autoscale key or do not
like the settings Autoscale has selected and want to return to your previous
settings.
settings.
• To set the instrument to the factory-default configuration, press the
Save/Recall
key, then press the
Default Setup
softkey.
Example
Connect the oscilloscope probes for channels 1 and 2 to the Probe Comp output
on the front panel of the instrument. Be sure to connect the probe ground leads
to the lug above the Probe Comp output. Set the instrument to the factory
default configuration by pressing the
on the front panel of the instrument. Be sure to connect the probe ground leads
to the lug above the Probe Comp output. Set the instrument to the factory
default configuration by pressing the
Save/Recall key, then the Default Setup
softkey. Then press the
Autoscale key. You should see a display similar to the
following.
Autoscale with analog channels