Lucent Technologies partner voice messaging card User Manual
VMS Cover Rings (#117)
Check Form A, to see if VMS Cover Rings is different from the factory setting
of 3. If it is, follow the procedure below beginning with Step 1. If not, skip to
Step 3 of the procedure below.
of 3. If it is, follow the procedure below beginning with Step 1. If not, skip to
Step 3 of the procedure below.
To change the number of times calls ring before they are sent to the voice
messaging system as indicated on Form A, Page 2, VMS Cover Rings:
messaging system as indicated on Form A, Page 2, VMS Cover Rings:
1.
2.
3.
4.
Press [
#
] [
1
] [
1
] [
7
].
Enter the VMS Cover Rings setting (1–9) specified on Form A.
Press [
Feature
] [
0
] [
0
] to exit programming mode.
Continue with the next section, "Telephone Button Programming."
Telephone Button Programming
Before you begin, locate Form C of the System Planner for the
communications system. Be sure you have a copy of the form for each
subscriber's phone.
subscriber's phone.
Use this section to program buttons on subscribers' phones, including the
receptionist's phone. This section uses Centralized Telephone Programming.
receptionist's phone. This section uses Centralized Telephone Programming.
When you are finished programming, be sure to label all buttons on
subscribers' phones.
Manual VMS Cover (F15)
This button allows the subscriber to turn voice mail coverage and off.
To program a VMS Cover button as specified on Form C:
1 .
Press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
] [
Central Tel Program
].
2 .
Enter the number of the extension to be programmed.
3.
Press a programmable button with lights.
4 .
Press [
Feature
] [
1
] [
5
].