SharkRack 45U User Manual

ID-00210-000 

REV D, ECO2773 

Page 22 of 46 

 
 
 
 
 
 
 

 

The Retractable Tip Guard should be used when the 
cabinet is not secured to the floor and equipment is being 
slid in and out of the cabinet. This feature is used to 
prevent the cabinet from tipping over. 

 

1. Insert the legs of the tip guard into the base of the 

cabinet.  Detent the spring latches towards the rear of 
each leg.   

 

42U X 37DP Shown 

2. Check the operation of the Retractable Tip Guard. It 

should freely cycle through its full range of motion.  

Note: Some adjustment of the center section may be 

required for smooth operation.  To adjust loosen the (4) 
screws at the front of the Tip Guard.  Reposition the 
pieces as required.  Tighten the screws. 

Note: When in use, remember to fully lower both leveling 

feet on the retractable stabilizer kit until they are firmly 
planted on the floor. 

42U X 37DP Shown