Siemens C79000-G8976-C156-07 User Manual
13
SIMATIC NCM PC Project Engineering Tool
168
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
13.4
Configuring a PC Station with SIMATIC NCM PC Config
Creating an Image of the PC Configuration
To allow the configuration data sent by the configuration system to be assigned to
a module or an application, it must have a unique identification number. The
identification number for modules, applications, and other components in a PC
station is the index.
a module or an application, it must have a unique identification number. The
identification number for modules, applications, and other components in a PC
station is the index.
You place your applications and modules in slots in a “virtual rack” in HW Config.
This slot number then corresponds to the index mentioned above.
This slot number then corresponds to the index mentioned above.
Virtual rack in the PC station
Figure 13-1
Component Management of a PC Station
Note:
This procedure corresponds to the one already described for the “Station
Configuration Editor” tool.
This procedure corresponds to the one already described for the “Station
Configuration Editor” tool.
Notice
Be careful not to confuse this “index” with a hardware slot, for example on the PCI
bus of the PC station. The slot on the PCI bus is not relevant for commissioning
and is not used at any point.
bus of the PC station. The slot on the PCI bus is not relevant for commissioning
and is not used at any point.