Multi-Tech Systems MTCBA-E-EN User Manual

Chapter 3 – Using the Web Management Software 

Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F) 

 

 

On the 

 screen, set up the following parameters: 

• 

Make sure that PPP is Enabled (the default). 

• 

Make sure Dial-on-Demand is Enabled (the default). 

• 

Set the Idle Time Out to the number of seconds you desire. 

• 

Your wireless service provider may require you to have a separate PPP username and 

. If so, enter them here. Note: If a username and password are required, your 

wireless provider would have given them to you when you activated your account. 

• 

Make sure your Dial Number is entered correctly:    

For CDMA, it is #777 
For GPRS and EDGE, it is *99***1# 

• 

Make sure your Init String 1 is setup correctly.    

For GPRS and EDGE, Init string 1 should be the APN  
(i.e.,  AT+CGDCONT=1,"IP","internet") 

• 

Click the Submit button to save the changes made on this screen. 

 

On the 

 screen, set up the following parameters: 

• 

Select Enable for Wakeup-on-Call. 

• 

Set the Time Delay. Use can use the 10 second default.  

• 

Enter the Init Strings: 

Set Wakeup Init String 1 by entering AT+CLIP=1 
Set Wakeup Init String 2 by entering AT+CICB=0 (CDMA only)  

• 

 Button 

Click the Submit button to save these settings.  

• 

Enter a caller’s ID that you want added to the Caller ID list.  

• 

 Button  

Click the Add button to save each Caller ID as it is entered to the Caller ID list.  

Click Save and Restart once you have completed and submitted all the screens on which you 
have made changes. The device will save all the settings and reboot the PC.