Lucent Technologies 9077 16S User Manual

SP Switch Router Adapter card LEDs

SP Switch Router Adapter Guide - 1.4 Update 2

 

1-11

Refer to Table 1-2 for a description of SP Switch Router Adapter card LED activity during 
normal run time operations.              

PWR ON

This green LED is on when 5 volts are present. Both power LEDs, 
5V and 3V, can be on simultaneously. 

3V

This green LED is on when 3 volts are present.

RX HB (green)

During normal run-time operations, this green LED blinks a 
“heartbeat” pattern for the receive side CPU. The beat is a long off, 
short on-off-on pattern .

In the pattern, the LED goes off for 1/2 second, comes on for 1/4 
second, goes off for 1/4, comes on for 1/4, and then begins the 
pattern again by going off for 1/2 second.

• RX ST0 (green)
• RX ST1 (amber)
• RX ERR (amber)

These three LEDs 
light in different 
combinations to 
indicate 
five operating states 
for the receive port.

•  ON      STATE_0    -  These three LEDs are on during 
•  ON                             hardware initialization. 
•  ON

•  OFF     STATE_1   - Bottom two amber LEDs go on during 
•  ON                            software initialization, show receive port
•  ON                            is waiting for configuration parameters.

•  ON      STATE_2   - Middle amber LED goes off when 
•  OFF                          configuration parameters are in place and the
•  ON                            receive port is ready to be connected. 

•  OFF     STATE_3   - Bottom amber LED goes on to show that
•  OFF                          the receive port is connected and the card is 
•  ON                             ready to be on line

•  OFF     STATE_4   -  These three LEDs are off to show receive
•  OFF                           port is online and running/routing.
•  OFF

MD RCV (amber)

This amber LED lights when data comes into the receive media port 
from an external source.

SW XMIT (amber)

This amber LED lights when the receive media port sends data to the 
SP Switch Router switch core (via the serial daughter card).

TX HB  (green)

This green LED blinks a “heartbeat” pattern for the transmit side 
CPU, the beat is a long off, short on-off-on pattern during normal run 
time operations.

In the pattern, the LED goes off for 1/2 second, comes on for 1/4 
second, goes off for 1/4, comes on for 1/4, and then begins the 
pattern again by going off for 1/2 second.