Lucent Technologies 6000 User Manual

5-20

   Preliminary January 4, 2001   

MAX 6000/3000 Network Configuration Guide

Configuring Frame Relay
Concentrating incoming calls onto Frame Relay

In addition to the attributes described in “Overview of DLCI interface settings” on page 5-13, 
the following attribute-value pairs must be specified in the permconn profile of a Frame Relay 
gateway:

In the following example, the MAX acts as a gateway between a client that dials in with the 
address 10.1.2.3/29, and a remote router that is reachable across Frame Relay, as shown in 
Figure 5-8:

The following set of parameters configures an MP+ Connection profile for the dial-in client in 
Figure 5-8:

Ethernet

Connections

mpp-client

Name=mpp-client

Active=Yes

Encaps=MPP

Encaps options

Recv PW=clientpw

IP options

LAN Adrs=10.1.2.3/29

Following is a comparable RADIUS profile:

mpp-client Password="clientpw", User-Service=Dialout-Framed-User

    Framed-Protocol=MPP,

    Framed-Address=10.10.1.3,

    Framed-Netmask=255.255.255.248

Ascend-Route-IP (228)

Enables/disables IP routing for this connection. (IP is enabled by 
default. If this attribute is present, it must be set to Route-IP-Yes 
for Frame Relay gateway connections.)

Framed-Address (8)

Destination IP address, which lies at the end of a PVC whose first 
hop is known by the specified DLCI.

Framed-Netmask (9)

A subnet mask for Framed-Address.