Lucent Technologies 6000 User Manual

Page of 586
Configuring X.25
Configuring X.25 PAD connections
MAX 6000/3000 Network Configuration Guide
 6-13
For detailed information about each parameter, see the MAX Reference.
Configuring an X.25 PAD connection
This section shows a sample configuration in which the MAX immediately directs the X.25 
modem caller to a PAD interface on the host whose X.121 address appears in Figure 6-2.
Figure 6-2.  Example of a X.25 PAD connection
To configure this sample X.25 PAD connection.
1
Open the Answer profile and enable X.25/PAD encapsulation.
2
Open a Connection profile, name it, and activate the profile.
3
Enable X.25/PAD encapsulation.
PAD prompt
The PAD prompt parameter specifies the prompt the user or the calling 
device sees when running an X.25 (Triple-X) PAD session on the MAX. 
The PAD user can either be a human user or a calling device running a 
script. You can specify up to 12 characters. The default is null. (Packet 
Assembler/Disassembler (PAD) is an asynchronous terminal concentrator 
that enables several terminals (or other asynchronous devices) to share a 
single network line. PAD-generated packets are transported using the X.25 
protocol.)
NUI prompt
The message that prompts for the user’s Network User Identification (NUI) 
to begin an X.25 (Triple-X) PAD session on the MAX. The PAD user can 
either be a person or a calling device running a script. You can specify up to 
15 characters. The default is null. A value in NUI prompt overrides any 
value entered in the NUI setting.
NUI PW 
prompt
The NUI password prompt for a PAD application. The value in this 
parameter prompts for the user’s Network user Identification (NUI) 
password to begin an X.25 (Triple-X) PAD session on the MAX. The PAD 
user can either be a human user or a calling device running a script. You can 
specify up to 12 characters. The default is null.
PAD Alias #N
Each of the three parameters each can declare an alias for an X.25 
command. When the calling device uses a script to communicate with the 
X.25 (Triple-X) PAD of the MAX, the script might send X.25 commands 
using terminology that the MAX must interpret. If the MAX receives an 
X.25 command that contains an alias established by a PAD Alias #N it 
interprets the command as set in the parameter. You can specify up to 40 
characters. The default is null. For one command string (including a space) 
to be treated as equivalent to another, you must insert a slash (/) must be 
placed between the two strings. 
Parameter
Specifies
WAN
MAX
311021755555