Lucent Technologies 7820-0657-001 User Manual
Viewing configuration information
DSLPipe DSU (SDSL) User’s Guide
3-3
Press any key on the keyboard and the DSLPipe unit’s configuration menu
appears:
appears:
Figure 3-1. DSLPipe configuration window
Note:
At this time, you cannot change DSLPipe configuration, upgrade the
DSLPipe software, or upgrade the DSLPipe firmware using the on-board
software. In other words, you cannot change anything by using options
software. In other words, you cannot change anything by using options
1
,
2
, or
3
from the DSLPipe configuration window (see Figure 3-1).
Viewing configuration information
After you set up the communications software and the DSLPipe unit’s
configuration menu appears (see Figure 3-1), you can enter 0 to view DSLPipe
status information. The DSLPipe status screen continues to refresh every few
seconds -- press any key to stop the refresh. Table 3-1 describes the fields that
display in the status window.
configuration menu appears (see Figure 3-1), you can enter 0 to view DSLPipe
status information. The DSLPipe status screen continues to refresh every few
seconds -- press any key to stop the refresh. Table 3-1 describes the fields that
display in the status window.
SDSL V.35 DSU
Software Version 3.31
0. Show DSL Status
1. Change Configuration
2. Upgrade Operation Software
3. Upgrade SDSL Firmware
4. Debug Mode
Table 3-1. Fields in the DSLPipe status window
Fields
Description
Bitpump Status
Shows either
OK
or
NG
(No Good).
Terminal Type
Indicates
CO
(Central Office) or
RT
(Remote Terminal) mode.
Operation Status
Indicates
UP
or
DN.