Enterasys Networks 1H582-xx User Manual
Preparing the Device for Router Mode
Configuring VLANs for IP Routing
3-94
Example
The example in
shows how to configure two VLANs for IP routing. VLAN 10 is set on
Fast Ethernet front panel port 1 with an IP address of 182.127.63.1, and VLAN 20 is set on Fast
Ethernet front panel port 2 with an IP address of 182.127.62.1. The configuration is then saved to
NVRAM in file called startup.cfg.
Ethernet front panel port 2 with an IP address of 182.127.62.1. The configuration is then saved to
NVRAM in file called startup.cfg.
Step 4
Disable GVRP on
the dedicated routing
port.
the dedicated routing
port.
set gvrp disable
port-string
port-string
Switch:
(Matrix>)
(Matrix>)
Step 5
Repeat steps 1 through 4 to create additional VLAN(s).
Step 6
Enable router mode.
router
Switch:
(Matrix>)
(Matrix>)
Step 7
Enable global router
configuration mode.
configuration mode.
configure
terminal
terminal
Router:
Matrix>Router#
Matrix>Router#
Step 8
Enable interface
configuration mode.
configuration mode.
interface vlan_id
Router:
Matrix>
Router(config)#
Matrix>
Router(config)#
Step 9
Assign an IP address
to the VLAN.
to the VLAN.
ip address
{ip_address
ip_mask}
{ip_address
ip_mask}
Router:
Matrix>
Router(config-if
(Vlan
<vlan_id>))#
Matrix>
Router(config-if
(Vlan
<vlan_id>))#
Step 10
Enable the VLAN
for IP routing.
for IP routing.
no shutdown
Router:
Matrix>
Router(config-if
(Vlan 1))#
Matrix>
Router(config-if
(Vlan 1))#
Step 11
Repeat steps 6 through 10 to configure additional VLAN(s) for IP routing.
Step 12
Save the routing
configuration to
NVRAM.
configuration to
NVRAM.
write file
filename
config_file
filename
config_file
Router:
Matrix>Router#
Matrix>Router#
Table 3-9
Command Set for Configuring VLANs for IP Routing (Continued)
To do this task...
Type this
command...
command...
In this mode...
For details,
see...
see...