Enterasys Networks 1H582-xx User Manual
SNMP Command Set
Configuring SNMP Target Parameters
5-37
5.2.5
Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (
Commands
The commands needed to review and configure SNMP target parameters are listed below and
described in the associated section as shown.
described in the associated section as shown.
•
show snmp targetparams (
•
set snmp targetparams (
)
•
clear snmp targetparams (
5.2.5.1
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
show snmp targetparams [targetparams]
Syntax Description
Command Defaults
If targetParams is not specified, entries associated with all target parameters will
be displayed.
be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
targetparams
(Optional) Displays entries for a specific target
parameter.
parameter.