Enterasys Networks CM Version 1.0 User Manual
Pre-Installation Tasks
Matrix X Router DC Power Supply Installation Guide
1-5
Pre-Installation Tasks
Complete the following tasks before installing the DC power supply:
•
•
Verify DC Power Compliance of Matrix X Modules
All installed modules must meet both the 940 part number and the 940 revision minimum
requirements for DC power.
requirements for DC power.
•
If you are converting an existing AC‐powered Matrix X Router system to DC power
follow the procedure in
follow the procedure in
•
If the system is a new a Matrix X DC‐powered installation follow the procedure in
Converting Existing AC-powered Matrix X Router Systems to DC
If the system currently uses AC power and is transitioning to DC, follow this procedure to
verify DC power compliance of all modules.
verify DC power compliance of all modules.
1.
From the CLI, run the show system hardware command. In the following
example, output from running the show system hardware cm 1 command is
shown to illustrate information for a DC power‐compliant CM module.
example, output from running the show system hardware cm 1 command is
shown to illustrate information for a DC power‐compliant CM module.
matrix-x(switch-su)-> show system hardware cm 1
CM SLOT 1
Model: CM Version 1.0
State: Active
905 Part number: 9053454000
905 Serial number: 07420507635A
940 Part number: 9404179000
940 Serial number: 07475281635A
Part number: X-CM-00
[truncated]