Proxim AP-2500 User Manual
204
Using the Command Line Interface
Configure Management Ports
[Device Name]>set snmpifbitmask <0, 1, 4, 8, 15
(see below)>
[Device Name]>set httpifbitmask <0, 1, 4, 8, 15
(see below)>
[Device Name]>set telifbitmask <0, 1, 4, 8, 15
(see below)>
Choose from the following values:
Edit IP Access Table
[Device Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Configure Serial Port Interface
[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device Name]>set serflowctrl <none, xon/xoff>
[Device Name]>show serial
Figure A-14 Result of “show serial” CLI Command
NOTE
To avoid unexpected performance of your AP-2500, leave the setting Flow Control to its default value (none)
unless you are sure what this setting should be.
unless you are sure what this setting should be.
Interface bitmask
Description
0 = disable (all interfaces)
All management channels disabled
1 = ethernet if
Ethernet only enabled
4 = pcCardA if
Wireless A only enabled
8 = pcCardB if
Wireless B only enabled
15 = allInterfaces
All management channels enabled