TP-LINK TD-W8950ND User Manual
TD-W8950ND
150Mbps Wireless N ADSL2+ Modem Router User Guide
enable the Virtual LAN Ports feature.
¾
Add: Click the Add button, and you can add a new interface in the next screen.
Figure 4-5
¾
ETH port: Select an ETH port to configure as the WAN port.
Click Save/Apply to save your settings and then you will see the screen similar to Figure 4-6.
Figure 4-6
¾
Remove: Select the check box in the table on the screen above and then click the Remove
button, the corresponding interface will be deleted in the table.
)
Note:
One ETH is allowed to configure as the layer 2 WAN Interface.
4.4.2 WAN Service
Choose “Advanced Setup”Æ“WAN Service”, and you will see the WAN Port Information Table in
the screen similar to Figure 4-7, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
below to complete the further configuration of WAN Interface. There are five different
configurations for the connection types, which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You
can select the corresponding types according to your needs.
the screen similar to Figure 4-7, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
below to complete the further configuration of WAN Interface. There are five different
configurations for the connection types, which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You
can select the corresponding types according to your needs.
21