3M 40800 User Manual
20
8.1 Description of the Working Cycle
After having closed the top fl aps of the carton, the
operator pushes it under the top infeed end in order
to avoid the opening of the top fl aps. Further push-
ing causes the two top and bottom belts to drive the
box through the taping heads which automatically
seal the top and bottom seams. The carton is then
expelled on the exit conveyor.
operator pushes it under the top infeed end in order
to avoid the opening of the top fl aps. Further push-
ing causes the two top and bottom belts to drive the
box through the taping heads which automatically
seal the top and bottom seams. The carton is then
expelled on the exit conveyor.
8.2 Definition of Running Mode
The case sealer
700a has only one (automatic)
operating mode with:
- The EMERGENCY STOP BUTTON unlocked
(Figure 8-1)
- The main switch start switch “ON” (I)
(Figure 8-2)
8.3.1 Normal Stop Procedure
When the main switch is turned OFF (O), the ma-
chine stops immediately at any point of the working
cycle. The same thing happens in case of electrical
failure or when the machine is disconnected from the
mains.
chine stops immediately at any point of the working
cycle. The same thing happens in case of electrical
failure or when the machine is disconnected from the
mains.
8.3.2 Emergency Stop
The LATCHING EMERGENCY STOP BUTTON is
located on the top center of the machine
located on the top center of the machine
(Figure 8-1).
8-THEORY OF OPERATION
Figure 8-3
2011 June
700a-NA
E-Stop Location
Belt
Direction
Figure 8-1
Figure 8-2
Figure 8-3