3M 40800 User Manual

22 

Both the top and bottom taping units have a blade 
guard.  (See Manual 2:  

Heads - 2 Inch).

The box drive belts are turned on and off with the 
electrical switch on the side of the machine frame.

The machine electrical supply can be turned off 
by pressing the latching emergency stop switch. 
To restart machine, rotate the emergency stop 
switch clockwise to release the switch latch.  
Restart machine by pushing the Start button

2011 June

700a-NA 

•  

−    Position electrical cord away from foot 

    and vehicle traffi c.

• 

− 

Keep hands and fi ngers away from tape 
cutoff blades under orange blade guards. 
The blades are extremely sharp.

10.3  Electric System / Circuit Breaker
The electric system is protected by a ground wire 

whose continuity has been tested during the fi nal 

inspection. The system is also subject to insulation 

and dielectric strength tests.

•

  

−  

Allow only properly trained and 

  qualifi ed personnel to operate and service 
  this equipment.

The case sealer is equipped with a circuit breaker 

which trips if the motors are overloaded. Located 

inside the electrical enclosure on the side of the 

machine frame just below the machine bed, the 

circuit breaker has been pre-set amps and requires 
no further maintenance.

1.  Determine cause of overload and correct.

2.  Plug in machine.

3.  Press machine "On" (I) button to resume  

case sealing.

If circuit is overloaded and circuit breaker trips, 

unplug machine from electrical power:

The use of an extension cord is not 

 

recommended. However, if one is needed for 

 

temporary use, it must: 

• 

Have a wire size of 1.5mm diameter [AWG 16]

• 

Have a maximum length of 30.5m [100 ft]

• 

Be properly grounded.