SATO 10e User Manual
Section 8: Adjustment Procedures
SATO M10e Service Manual
PN 9001113A
Page 8-17
5 Press the LINE or FEED key as required to adjust the print width.
6 Press the ENTER key to select and begin test printing.
6 Press the ENTER key to select and begin test printing.
7 Adjust the OFFSET (VR2) potentiometer as necessary to gain the desired position.
LCD DISPLAY ADJUSTMENT
This procedure allows illumination intensity adjustment of the LCD display. Adjustment is
performed by the use of the DISPLAY potentiometer located on the operator panel. The operator
panel is located on the upper surface of the left housing cover. To adjust the LCD display, turn on
the printer, confirm that the LCD display is illuminated and a message is displayed. If either are
not present, adjust the DISPLAY (VR4) potentiometer as necessary to achieve the desired
setting.
performed by the use of the DISPLAY potentiometer located on the operator panel. The operator
panel is located on the upper surface of the left housing cover. To adjust the LCD display, turn on
the printer, confirm that the LCD display is illuminated and a message is displayed. If either are
not present, adjust the DISPLAY (VR4) potentiometer as necessary to achieve the desired
setting.
PRINT DARKNESS ADJUSTMENT
Fine adjustment of print darkness is performed by use of the PRINT potentiometer located on the
operator panel. The operator panel is located on the upper surface of the left housing cover. To
adjust the print darkness, adjust the PRINT (VR1) potentiometer as necessary to achieve the
desired setting. This adjustment will affect all label formats.
operator panel. The operator panel is located on the upper surface of the left housing cover. To
adjust the print darkness, adjust the PRINT (VR1) potentiometer as necessary to achieve the
desired setting. This adjustment will affect all label formats.
LCD DISPLAY: TEST PRINT SIZE
26CM
26CM
NOTE: The ENTER key may be used to cease and resume printing activity.