SATO 10e User Manual
SATO M10e Service Manual
PN: 9001113A
Page 9-1
9
FACTORY RESETS
This section of the service manual covers instructions on how to return the printer to its factory
settings. The instructions are separated into differing catagories of interest.
settings. The instructions are separated into differing catagories of interest.
FACTORY SETTINGS / TEST PRINT
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Simultaneously, press and hold the LINE and FEED keys while turning on the power
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Simultaneously, press and hold the LINE and FEED keys while turning on the power
switch.
5 Release the LINE and FEED keys upon hearing a beep.
6 Place the DSW2-4 in the Off position.
7 Press the ENTER key to advance to the next display.
8 Use the CURSOR keys to change from option NONE to option ALL.
9 Press the ENTER key to clear the EEPROM.
10 Use the CURSOR keys to select the desired option.
CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
LCD DISPLAY: MAINTENANCE MODE
DIPSW2-4 NO>OFF
DIPSW2-4 NO>OFF
LCD DISPLAY: FACTORY MODE
LCD DISPLAY: COUNTER CLEAR - NONE
LCD DISPLAY: COUNTER CLEAR - ALL
LCD DISPLAY: PRINT SIZE
SMALL LARGE
SMALL LARGE
NOTE: The default selection is large. The CURSOR keys allow scrolling from
one option to another.
one option to another.