SATO D512 User Manual
Section 3: Configuration and Operation
Page 3-8 SATO D508/D512 Operator Manual
3.5 OFFSETS
There are two offset settings stored in the printer; one for the Cut mode and one for the Tear-Off
mode.
mode.
These two offsets can be set independently and will remain in the printer until a new command is
received changing the setting or until power is turned off.
received changing the setting or until power is turned off.
The default settings can be determined by printing a User Test Label.
The following should be used as starting points for establishing the three Offset values:
Mode
Length of Offset (mm) Length of Offset (in) Print head resolution
CUTTER
17.9
0.70
143/215
TEAR-OFF
29.2
1.15
234/350