HP (Hewlett-Packard) CP4005 User Manual

  No display message

The printer’s on/off button is in the standby position.

Verify that the printer is on. Fans might run while the printer is
in standby mode (off).

The printer’s memory DIMMs are defective or installed
incorrectly.

Verify that the printer’s memory DIMMs are correctly installed
and are not defective.

The power cord is not firmly plugged into both the printer and
the power receptacle.

Turn off the printer and then disconnect and reconnect the
power cord. Turn the printer back on.

The line voltage is incorrect for the printer power configuration. Connect the printer to a proper voltage source, as specified on

the Power Rating Label on the back of the printer.

The power cord is damaged or excessively worn.

Replace the power cord.

The power source receptacle is not working correctly.

Connect the printer to a different power receptacle.

  Printer is on, but nothing prints

The printer’s Ready indicator light is not lit.

Press 

Stop

 to return the printer to the Ready state.

The top cover is not closed properly.

Close the top cover firmly.

The 

Data

 indicator light is flashing.

The printer is probably still receiving data. Wait for the 

Data

indicator to stop flashing.

REPLACE [COLOR] CARTRIDGE appears on the printer
display.

Replace the print cartridge specified on the printer display.

A printer message other than Ready appears on the printer
control panel.

See 

The output bin is full.

Remove some or all of the media in the output bin.

The PS (PostScript Emulation) personality is not selected.

Select PS or AUTO for the printer language. For more
information, see 

The correct driver is not selected in the software application or
printer driver.

Select the driver for PostScript Emulation for this printer in the
software application or printer driver. For more information,
see 

.

The printer is not properly configured.

See 

.

ENWW

Printer response problems

199