HP (Hewlett-Packard) 3020 User Manual

To reduce or enlarge copies for the current job only, use the following instructions.

1. On the device control panel, press 

REDUCE

/

ENLARGE

.

2. Select the size to which you would like to reduce or enlarge the copies in this job. You can

select one of the following sizes:

●

●

●

●

●

●

●

●

●

●

If you select Custom: 25-400%, type a percentage by using the alphanumeric buttons.

If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or
landscape).

3. Press 

START

/

COPY

 to save the selection and immediately start the copy job, or press 

MENU

/

ENTER

 to save the selection without starting the job.

The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control panel display.

You must change the default media size in the media input tray to match the output size, or
part of your copy might be cut off. For instructions, see 

.

The default copy size is the size to which copies are normally reduced or enlarged. If you keep
the factory default size setting of Original=100%, all copies will be the same size as the
original document.

1. Press 

MENU

/

ENTER

.

2. Use the 

<

 or the 

>

 button to select Copy setup, and then press 

MENU

/

ENTER

.

3. Use the 

<

 or the 

>

 button to select Def. Redu/Enlrg, and then press 

MENU

/

ENTER

.

Chapter 4 Copying

ENWW