Emerson GXT 10KVA User Manual

These installation instructions provide all the information needed for positioning the Nfinity Mainte-

nance Bypass Cabinet (including environmental requirements) and for connecting the input and out-

put power cables.

Upon receiving the Nfinity Maintenance Bypass Cabinet, examine the packaging for any signs of mis-

handling or damage. If any damage is noted, contact your local dealer or Liebert representative and 

notify your carrier.

The Maintenance Bypass Cabinet environment must be free of conductive contaminants and exces-

sive moisture (water condensation), flammable vapors, chemical fumes, or corrosive gases and liquids.

The tools below are required in order to properly setup your maintenance bypass cabinet:

• pallet  jack
• 1/2" (13 mm) wrench
• torque wrench 
• flat-head screwdriver
• #2 Phillips screwdriver
• 3/16" (5 mm) Allen wrench

When deciding where to locate your Maintenance Bypass Cabinet, consider the weight and size of the 

unit. Make sure that the structural integrity of the floor can withstand the weight. Refer to the table 

below for dimensional considerations:

Check to make sure that your Maintenance Bypass Cabinet will be located in a well-ventilated area 

with at least 12 inches (304mm) in front of and behind it. Transformer based models are forced air 

cooled with the aid of two internal cooling fans.

Model

With Transformer

Without Transformer

W x D x H

In (mm)

9.5 x 26.5 x 30.4

(241.3 x 673.1 x 772.16)

Weight

287 lbs (130 kg)

85 lbs (38 kg)